Everything for Electronics
Nuts & Volts Magazine (November 2008)

ROBOBENCH : Putting the CrustCrawler AX-12+ “Smart Arm” To Work

By Vern Graner    View In Digital Edition  


It’s inevitable. When working on a project at your workbench, at some point you’ll wish that you had a third hand. When you’re holding together two parts that need to be soldered or you need a screwdriver but you don’t want to take your eyes off of some small parts to reach for it, an extra hand would be awfully uhm ... “handy.”

:::

Read This Article!
If you’re a subscriber and your subscription includes this issue of Nuts & Volts, you can read this article in our digital edition by clicking the blue icon in the upper right corner. Use the email address associated with your subscriber services account to login.

If you're a member of our Preferred Subscriber Network, not only will the magic blue icon let you read this article, but EVERY article in EVERY issue is yours to enjoy! Over a decades worth of content is stored in our digital archive!

If you’re not a subscriber, you can still view a few sample pages of our digital edition or subscribe here for full digital access and/or print delivery. Also, as you browse around our site, you will find selected articles have been posted in their entirety for you to enjoy.




Comments